Introduction of oiling method for slider of laser marking machine

The Laser Marking Machine is also partly carried out by machinery during the work process, because it must wear on the machine, so it is necessary to lubricate the slider, because working for a long time will make the laser marking machine The decrease in work efficiency also has a great impact on its life!

So how do we oil laser marking machines that are different from metal marking machines?

First of all, you must turn off the power of the laser engraving machine, and use a hex wrench to remove the lens on the slider. Be careful when removing the lens. Pay attention to protecting the lens. At this time, hold the guide rail in reverse and expose the connection between the slider and the guide rail. , If the slider is short of oil, you will see the balls are shiny at this time. When lubricating, squeeze the lubricating oil from the needle tube a little, add the oil to the gap with a wooden toothpick, and roll the slider when adding oil in turn. Let the lubricating oil stain each ball as much as possible; finally, after finishing the oil, do not rush to fix it, let the slider roll back and forth on the guide rail, then you must install the guide rail secondly, pay attention not to fix it first when installing the guide rail, To install all the fixing nails, keep the level, and then fix the belt and the slider, and finally install the lens of the laser marking machine, adjust the way to X.