From the perspective of the current office printing market, the inkjet all-in-one machine is one of the most concerned products in the market. At the same time, the sales of the inkjet all-in-one machine in the market have been very good for several consecutive years. I believe many friends around you are using this type of product. product. When any product is used to a certain extent, some problems will occur, so everyone needs a solution to the problem. Below I will share with you the daily maintenance and maintenance skills of the inkjet all-in-one machine. Helpful.
Clean the printing system
As a commonly used inkjet machine, frequent cleaning is essential. In general, inkjet printing can be cleaned and maintained every time the Ink Cartridge is replaced. The cleaning procedure is also very simple, just wipe with a damp cloth. Of course, if necessary, you can also use a soft brush or vacuum cleaner to remove fine paper dust and dust in the paper path.
It should be noted that do not allow water, alcohol, or other cleaning liquids to enter the inside of the printing unit, which may damage the all-in-one. In addition, the noise from the back and forth movement of the stand is normal, so no need to worry.
Cleaning and maintenance
After using the all-in-one for a long time, handprints, stains and dust will inevitably be left on the glass plate, which will reduce performance and affect accuracy when copying or scanning. When cleaning the glass plate, turn off the power, gently wipe with a damp cloth, and finally use a soft, dry soft cloth to dry the glass plate. Be careful not to use corrosive liquids, which can cause damage to the content equipment. [next]
Calibrate and clean the print head
Calibrating the ink cartridge will ensure that the all-in-one drip ink correctly side by side when printing text or graphics. The most convenient method of calibration is to use the all-in-one utility to calibrate and clean the print head.
Select and confirm the correct model in the found all-in-one device and continue to install the all-in-one. After the driver installation is complete, you can use the all-in-one. Press the "Settings" button on the operation panel and select "Network" in the setting menu. Select "Wireless Setup Wizard" in the network menu interface.
Select and confirm the correct model in the found all-in-one device and continue to install the all-in-one. After the driver installation is complete, you can use the all-in-one.
How to manually clean the ink cartridge
If there is ink in the ink cartridge in the all-in-one, disconnections, color casts, etc. occur during printing, indicating that some nozzles in the ink cartridge may be blocked. If there is no significant improvement after using the all-in-one cartridge cleaning procedure, you can try to clean the cartridge manually.
Open the ink cartridge compartment and pull the ink cartridge out of the all-in-one machine to remove it. After removing the ink cartridge, find the nozzle of the ink cartridge, that is, the part with an integrated circuit at the bottom. This is the position of the nozzle. Prepare a small box of warm water at about 50-60 degrees, soak the nozzle at the bottom of the cartridge into the water for 3-5 minutes.
Remove the ink cartridge from the water and dry it with a little force. If it is normal for a small amount of ink to be ejected from the nozzle, do n’t worry. Find a clean napkin to absorb the ink at the nozzle of the ink cartridge. Be careful not to wipe the circuit board of the nozzle, which may cause the nozzle to block. Reinstall the cleaned ink cartridge back into the all-in-one machine and print a test page to see the cleaning effect. If there is no improvement, it is time to replace the ink cartridge.
