During the use of the system, care should be taken to maintain the equipment regularly to keep it in the best working condition. Maintenance work can be selected according to the user's own situation.
1. Maintenance of printing needle and needle sleeve
During the operation of the equipment, the printing needle repeatedly impacts up and down. Due to the friction between the needle sleeve and the printing needle, after a long time, the inner wall of the needle sleeve and the printing needle itself will be worn out, thereby increasing the gap between the needle and the needle sleeve Large, directly affects the printing effect. During maintenance, remove the printing needle from the needle sleeve, clean them with gasoline, dry it, add an appropriate amount of lubricant, and reload it. This work is carried out according to the frequency with which users use the device, and it is recommended to use it two to three times a week.
2. Maintenance of the printer head
The printer head is mainly composed of linear guides and motors. Since the guide rail directly faces the workpiece to be processed, the debris generated during the marking process of the workpiece and the dust and other impurities in the on-site environment are easily attached to the guide rail, which may cause the guide rail to wear out after a long time. The method to avoid is to clean the guide rail regularly with gasoline, and then add proper amount of lubricating oil after drying. This work is recommended to be done once every two weeks. At the same time, pay attention to avoid adding oil to the timing belt during the cleaning and oiling process.
3. Maintenance of the controller
Due to its own characteristics, the equipment is exposed to the air for a long time, and it is easy to accumulate dust in the circuit board after a long time, and it is easy to cause circuit short circuit if it is not cleaned for a long time. The way to clear is to turn off the power of the controller, open the cover of the box body, and blow the dust inside with clean friendly competition air. Usually pay more attention to the dustproof work outside the chassis.
4. Computer maintenance
After the computer runs for a long time, a lot of junk files will also be generated inside the system. If it is not cleaned up, it will directly affect the normal operation of the software. The work includes the following:
(1), regularly delete some junk files and unnecessary software files;
(2) Regularly organize the hard disk to ensure that the data of the hard disk is organized and speed up the speed of software operation;
(3) Don't add unknown files and software to the system in order not to be affected by viruses, so as to ensure that the system works in a non-toxic environment. This work has certain requirements for the operator's computer knowledge. Those who can use the computer skillfully can operate it by themselves, otherwise please consult our company staff before they can operate.
